Troubleshooting
6
150C5 LCD
Common Problems
Having this problem
?
Check these items
No Picture
(power LED not lit)
·
Make sure the power cord is plugged into the power outlet
and into the back of the monitor.
·
First, ensure that the power button on the front of the monitor is in
the OFF position, then press it to the ON position
No Picture
(Power LED is amber or yellow)
·
Make sure the computer is turned on.
·
Make sure the signal cable is properly connected to your computer.
·
Check to see if the monitor cable has bent pins.
·
The Energy Saving feature may be activated
Screen says
·
Make sure the monitor cable properly connected to your computer.
(Also refer to the
Q
uick Set-Up Guide).
·
Check to see if the monitor cable has bent pins,
·
Make sure the computer is turned on.
Screen says
·
Make sure the vertical sync of input signal is within the range of
56
--
75
Hz.
·
Change the refresh rate to
56
--
75
Hz within
10
minutes.
·
Re-power on monitor to start over again if you failed to change the
refresh rate within
10
minutes.
AUTO button not working properly
·
The Auto Function is designed for use on standard Macintosh or
IBM-compatible PCs running Microsoft Windows.
·
It may not work properly if using nonstandard PC or video card.
Image Problems
Having this problem
?
Check these items
Display position is incorrect
·
Press the AUTO button
·
Adjust the image position using the Horizontal Position
and
/
or Vertical Position in OSD Main Controls.
Image vibrates on the screen
·
Check that the signal cable is properly connected to the
graphics board or PC.
Vertical flicker appears
·
Press the AUTO button
·
Eliminate the vertical bars using the Clock Adjustment of
VIDEO NOISE in OSD Main Controls.
Horizontal flicker appears
·
Press the AUTO button
·
Eliminate the horizontal bars using the Phase
Adjustment of VIDEO NOISE in OSD Main Controls.
The screen is too bright or too dark
·
Adjust the contrast and brightness on OSD Main Controls. (The
backlight of the LCD monitor has a fixed life span. When the
screen becomes dark or begins to flicker, please contact your
dealer).
An after-image appears
·
If an image remains on the screen for an extended period of time,
it may be imprinted in the screen and leave an after-image. This
usually disappears after a few hours.
An after-image remains after the power has
been turned off.
·
This is characteristic of liquid crystal and is not caused by a
malfunction or deterioration of the liquid crystal. The after-image
will disappear after a period of time.
Green, red, blue, and white dots remains
·
The remaining dots are normal characteristic of the liquid crystal
used in today
s technology.
This page deals with problems that can be corrected by the user.
http://jdwxzlw.com/?fromuser=华盛维修
家电维修资料网,免费下载各种维修资料