Philips HTB7530D/12, User Manual

Page: 34 / 50

32
EN
Update software through
USB
What you need
• A USB flash drive that is FAT or NTFS-
formatted, with at least 256MB of memory.
Do not use a USB hard drive.
• A computer with Internet access.
• An archive utility that supports the ZIP file
format.
Step 1: Download the latest software
1
Connect a USB flash drive to your
computer.
2
In your web browser, go to
www.philips.com/support.
3
At the Philips Support website, find your
product and locate the
Software and
drivers .
» The software update is available as a
zip file.
4
Save the zip file in the root directory of
your USB flash drive.
5
Use the archive utility to extract the
software update file in the root directory.
»
The files are extracted under the UPG
folder of your USB flash drive.
6
Disconnect the USB flash drive from your
computer.
Step 2: Update the software
Caution
•
Do not switch off the home theater or remove the
USB flash drive during the update.
1
Connect the USB flash drive containing the
downloaded file to your home theater.
• Make sure that the disc compartment
is closed and no disc inside.
2
Press (
Home
).
3
Select [Setup] , and then press OK .
4
Select [Advanced] > [Software update]
>
[USB]
.
5
Follow the onscreen instructions to
confirm the update.
»
Update process takes about 5 minutes
to complete.
» Once complete, the home theater
automatically switches off and restarts.
If it does not, disconnect the power
cord for a few seconds and then
reconnect it.
Update software through the
Internet
1
Connect your home theater to a home
network with a high-speed Internet access
(see 'Connect and set up a home network'
on page 14).
2
Press (
Home
).
3
Select
[Setup]
, and then press
OK
.
4
Select [Advanced] > [Software update] >
[Network]
.
»
If an upgrade media is detected, you
are prompted to start or cancel the
update.
» Downloading of the upgrading file may
take long, depending on your home
network condition.
5
Follow the onscreen instructions to
confirm the update.
»
Update process takes about 5 minutes
to complete.
»
Once complete, the home theater
automatically switches off and restarts.
If it does not, disconnect the power
cord for a few seconds and then
reconnect it.