31
EN
•
Operating temperature and humidity:
0°C to 45°C, 5% to 90% humidity for all
climates
•
Storage temperature and humidity:
-40°C to 70°C, 5% to 95%
Speakers
•
Output power: 2 x 20 W RMS (10% THD)
•
Speaker impedance: 4 ohm
•
Speaker drivers: 2 x racetrack (1.5" x 5") +
2 x 1" tweeter
Subwoofer
•
Output power: 40 W RMS (10% THD)
•
Impedance: 4 ohm
•
Speaker drivers: 105mm (4") woofer
Remote control batteries
•
2 x AAA-R03-1.5 V
Laser
•
Laser Type (Diode): InGaN/AIGaN (BD),
AIGaInP (DVD/CD)
•
Wave length: 405 ±7 nm (BD),
660 ±10 nm (DVD), 785 ±10 nm (CD)
•
Output power (Max. ratings): 20 mW (BD),
6 mW (DVD), 7 mW (CD)
Standby information
•
When the product remains inactive for
18 minutes, it automatically switches to
standby or networked standby.
•
The power consumption in standby or
networked standby is less than 0.5W.
•
To deactivate Bluetooth connection, press
and hold the Bluetooth button on the
remote control.
•
To activate Bluetooth connection, enable
Bluetooth connection on your Bluetooth
device, or enable Bluetooth connection via
the NFC tag (if available).
9 Troubleshooting
Warning
•
Risk of electric shock. Never remove the casing of the
product.
To keep the warranty valid, never try to repair
the product yourself.
If you have problems using this product, check
the following points before you request service.
If you still have a problem, get support at
www.philips.com/support.
Main unit
The buttons on the SoundStage do not work.
•
Disconnect the SoundStage from the
power supply for a few minutes, then
reconnect.
•
Make sure that the touch buttons surface
is not in contact with any conductive
material, like water drop, metal, etc.
Picture
No picture.
•
Make sure that the TV is switched to the
correct source for the SoundStage.
No picture on a TV connected through HDMI.
•
Make sure that you use a High Speed
HDMI cable to connect the SoundStage
and TV. Some Standard HDMI cables do
not display properly for some images, 3D
video, or Deep Color.
•
Make sure that the HDMI cable is not
faulty. If it is faulty, replace it with a new
cable.
•
Press and then
731
on the remote
control to restore the default picture
resolution.
•
Change the HDMI video setting, or wait
for 10 seconds for auto recovery (see
'Picture and video settings' on page 24).
