10
EN
Update CAM
CAM is controlled by an internal program
called firmware. Newer versions of the
firmware may have been released after you
have purchased CAM.
The software program called
Philips Songbird
can use your computer to check for firmware
updates that are available on the Internet.
Install
Philips Songbird
on your computer
(see chapter
Install software
) and follow the
instructions to update (see chapter
Manually
verify / update the firmware
).
Note
Your music files are not affected by a firmware
•
update.
Manually verify / update the firmware
1
Ensure that your computer is connected
to the Internet.
2
Connect CAM to the computer
(see section
Connect and charge
for
instructions).
3
On your computer, click
Start
>
Programs
>
Philips
>
Philips Songbird
to
launch the Philips Songbird application.
4
Click CAM in the left pane. Then, select
Tools
>
Check for updated firmware
in
the pop-up window
»
Philips Songbird
checks for updates
and installs new firmware from the
Internet, if available.
5
Follow the on-screen instructions to
update the firmware of CAM.
6
Wait until the update is completed, then
disconnect CAM from the computer.
CAM restarts after the firmware is
»
updated and is ready for use again.
Turn CAM on and off
1
To toggle between modes on and off,
slide and hold for approximately 2
seconds.
Automatic shut-down
CAM has an automatic shut-down feature that
can save battery power.
After 10 minutes in idle mode (no music plays,
no button is pressed), CAM turns off.
1
Slide and hold for approximately 2
seconds to turn CAM on again.
Lock the keys
CAM has a lock switch to prevent accidental
operation.
1
To lock the buttons when you play, move
the slider to position .
All buttons except the volume keys
»
are locked and the display shows a
lock icon.
2
To unlock the buttons again, move the
slider to the center position.
Select the mode
1
Slide the mode selector to switch
between modes.
