Technical Specifications, Connections, and Chassis Overview
1.
1.
Technical Specifications, Connections, and Chassis Overview
Introduction:
•
This manual is a supplement to the FTP2.4E_AAmanual
(3122 785 15460), and therefore only gives the additional
IBO Zapper information.
•
Figures can deviate due to the different set executions.
1.1
Connections
Note:
The following connector colour abbreviations are used
(acc. to DIN/IEC 757): Bk= Black, Bu= Blue, Gn= Green, Gy=
Grey, Rd= Red, Wh= White, and Ye= Yellow.
1.1.1
Rear Connections
Figure 1-1 Rear connections
CI Common Interface: PCMCIA
68p - See diagram K7
jk
Service Connector (UART)
1
- UART_TX Transmit
k
2
- Ground Gnd
H
3
- UART_RX Receive
j
DIGITAL AUDIO Cinch: S/PDIF - Out
Bk - Coaxial
0.2 - 0.6 V
PP
/ 75 ohm
kq
1.2
Chassis Overview
Figure 1-2 PWB location (photo from 50” SDI model)
2.
Safety Instructions, Warnings, and Notes
See Service Manual FTP2.4E_AA (3122 785 15460).
3.
Directions for Use
You can download this information from the following websites:
http://www.philips.com/support
http://www.p4c.philips.com
F_15750_007.eps
051005
AERIAL IN
EXT2
EXT1
R
L
R
L
EXT3
SUBW
OUT
CENTRE
IN
DVI
SERVICE
AUDIO
OUT
AUDIO
IN
MAINS
(LCD SETS)
MAINS
(PLASMA SETS)
SERVICE
SPDIF
CI
D
SIDE I/O PANEL
C
PDP AUDIO PANEL
A
PDP SUPPLY PANEL
(ONLY FOR FHP SETS)
H
SCART 3 PANEL
J
LED PANEL
E
CONTROL PANEL
AL
AL
AMBI LIGHT PANEL
AMBI LIGHT PANEL
B
SMALL SIGNAL BOARD
K
IBO ZAPPER MODULE
KS
IBO ZAPPER SUPPLY
(42” SETS ONLY)
F_15740_019.eps
101005
