important notes
mounting details electrical diagram
4 x Dry Contact Inputs
– Presented on a 2mm pitch 160mm
long ribbon cable.
1 x RS485 DyNet Port -
Available on a 5 way terminal block
with maximum conductor size of 2mm.
Powered from the DyNet Network
–
No need for an
external power supply.
Simple Installation -
Compact enclosure allows the device to
be conveniently placed near the device to be controlled. All
connections are accessible without disassembly
Motion Detector Mode
- Allows easy connection of third
party motion detectors to the DyNet RS485 network.
Read Instructions
– We recommend that you read this
Instruction Manual prior to commencement of installation.
Special Programming
– This device will only operate in basic
modes unless programmed via a computer. If programming is
required, contact your local agent for details. The factory default
settings are Area 1 Presets 1, 2, 3 and 4.
Installation Location
– Install in a dry location, close to the
equipment to be interfaced with.
Cable Length
– Cable to the ribbon cable flying leads should not
exceed 1000mm long.
RS485 Data Cable
– Use screened, stranded RS485 data cable
with three twisted pairs. Segregate from mains cables by 300mm
minimum. Connect devices in a ‘daisy chain’. A data cable that is
connected to an energised device is live. Do not cut or terminate
live data cables.
40 mm
Ribbon Cable
19
m
m
side view
top view
19
m
m
………
DPMI940
DyNet Auxiliary Input Interface
Installation Manual
features
