Philips AZT9500, Service Manual

Page: 10 / 30

2 -1
SERVICE HINTS
REPAIR POSITION COPPERSIDE
To get access to the copperside of the
printed board assembly proceed as follows:
1. Remove the bottom screws(6x)
2. Lift the bottom -cabinet
3. Supply the unit via external DC-sochet
4. Take care that the door switch is closed during
measurements
REPAIR POSITION COMPONENTSIDE
To get access to the compomentside of the
printed board assembly proceed as followed;
1. Remove the bottom screws(6x)
2. Open the CD-door
3. Lift the top-cabinet and put it backwards on the table
4. Supply the unit via the external DC-socket
5. Take care that the door switch is closed during
measurements
DISMANTLING THE CD-DOOR
To dismantle the CD-door proceed as
follows:
1. Dismantle bottom and printed board/drive assembly
2. Disconnect membrance keyboard
(flex-foil connector on copperside of printed board
3. Bend the cabinet rightwards downwards as indicated in
the picture above
Remark:Do not use screwdrivers or tools like that.
Sharp edges could damage hinge or cabinet part.