11
EN
9
To reattach the front panel, insert the
bottom hooks into the bottom of the
purifier first. Then, push the panel against
the body of the purifier.
10
Plug the air purifier into the power supply.
Press the
button to switch on the
purifier. Then, press and hold
for 3
seconds to reset the filter. The replacement
light (
滤网
1
) will turn off.
Note
•
Alternatively, you can clean the pre-filter by removing
the dust with a vacuum cleaner.
•
Make sure that the pre-filter is completely dry. If it is still
wet, bacteria may multiply in it and shorten the lifetime
of the pre-filter.
•
Make sure that the side with the two projections is
pointing towards you, and that all hooks of the pre-filter
are properly attached to the purifier.
7 Replace the
filters
Note
•
The indicator of the filter replacement (
滤网
2&3
)
indicates the activated carbon filter and HEPA filter
have to be replaced.
Replace the activated carbon
filter and the HEPA filter
Note
•
The activated carbon filter and the HEPA filter are not
washable nor vacuum cleanable.
Replace both the activated carbon filter and
HEPA filter when the indicator (
滤网
2&3
) goes
on. This will last for approximately 2 weeks.
On the last day of the 2 weeks, the indicators
will continue goes on. All buttons on the control
panel are locked except
button and
button. After resetting the filter, the control
panel unlock.
Tip
•
When you remove or insert filters, place the purifier
against a wall for more stability.
Note
•
Insert the filters in the correct position.
•
Make sure you place the filters in the order of HEPA
filter, and then the activated carbon filter.
•
Make sure that the side with the tag is pointing towards
you.
Summary of Contents for AC4005
Page 2: ......
