OccuSwitch DALI
User Guide
Page 34
4 .2 .8
Set application mode
The OccuSwitch DALI controller has 10 pre-defined
application modes . The default application mode is
Mode 1 (Cell office) . The IRT9090 can be used to set the
application mode .
1 Press the
Mode
button .
The LED on the transmitter starts to
blink .
2 Select the required mode by pressing
1...9
(for mode number
10
press
1
followed by
0
)
The LED will stop blinking, the mode is
now set within the remote .
3 Point the remote towards the
OccuSwitch DALI, and press the green
Send
button .
The remote sends all stored settings
(application mode, power-up state,
background lighting level and IR group) .
The luminaires will flash once to confirm the selection .
4 .2 .9
Background level
In some application modes, the light level of all outputs
is set to a “background” level if there is no movement
detection for 15 minutes . This background level is by
default set to 20% of the maximum output level, but can
be changed with the IRT9090 .
1 Press the
Background %
button .
The LED on the transmitter starts to
blink .
2 Select the background level (10% - 70%,
or “min .”) .
The LED will stop blinking, the
background level is now set .
3 Point the remote towards the
OccuSwitch DALI, and press the green
Send
button .
The remote sends all stored settings
(application mode, power-up state,
background lighting level and IR group) .
The luminaires will flash once to confirm the selection .
D
Note
The “Prolong time (background period)” is defined by
the application mode and cannot be changed .
70% G
min
100 h
group
link?
mode?
mode
power up background IR group
reset
add
pir
delay
daylight RF channel
0
0
off
save
on
I/II
O)))
A-G
zone
%
on/off
8
7
9
50% E
40% D
60% F
5
4
6
20% B
10% A
II
30% C
PL
BMS
W/C
2
1
3
test
config
scene
70% G
min
100 h
group
link?
mode?
mode
power up background IR group
reset
add
pir
delay
daylight RF channel
0
0
off
save
on
I/II
O)))
A-G
zone
%
on/off
8
7
9
50% E
40% D
60% F
5
4
6
20% B
10% A
II
30% C
PL
BMS
W/C
2
1
3
test
config
scene
