Symptom
Possible cause/Remedy
No picture
<
Verify if the supplied cables are connected properly. (The aerial cable to the
TV, the other aerial to your recorder, the power cables, ..)
<
Verify if you selected the correct source.
<
Verify if the child lock has been switched off.
Poor picture
<
Verify in the Manual installation menu if you have selected the correct TV
system.
<
Verify if your TV or house aerial isn't located too close to loudspeakers,
non-earthed audio equipment or neon lights, etc.
<
Mountains or high buildings can cause double pictures or ghost images.
Sometimes you can improve the picture quality by changing the direction of
the aerial.
<
Is the picture or teletext unrecognisable.Verify if you have entered the
correct frequency. See Installation, Manual installation, p. 27.
Poor colour
<
Select Factory reset in the Installation menu.
<
Verify the connections between the optional equipment and the TV.
No sound
<
Verify if the volume isn't at minimum.
<
Verify if the sound hasn't been muted with the
¬
key.
<
Verify the connections between the optional equipment and the TV.
The remote does
<
Verify if the remote is set correctly for the equipment your are using.
not function
<
Verify if the batteries are not dead. Replace the batteries.
You can still use the keys at the right side of the TV.
<
Select
TV
mode on your remote control.
<
When pressing a key and some key leds are blinking with a higher speed
and lower intensity than in a normal working condition, and your TV does
not react on the key press, remove the batteries out of the remote control
and put them back again.
The remote of
<
The infrared signals of the screen may influence the reception sensibility
connected equip-
of other peripherals.
ment does not
Solution: replace the batteries of the remote of other peripheral equipment.
function well
No photo or music
<
Verify if the source complies with a supported code.
play or in poor
quality
No stable or not
<
Verify if you have selected the correct VGA mode in your PC.
synchronised VGA
See Connect a PC, p. 46.
picture
<
Verify the connections between the PC and the TV.
No solution found
<
Switch off your TV off and then on again once.
for your picture or
Never attempt to repair a defective TV yourself.
sound problem
Verify with your dealer or call a TV technician.
Red blinking led
<
Unplug the mains cord for 10 seconds and insert it in again
50
EN
Troubleshooting
2555.2 en 19-06-2006 15:28 Pagina 50
