57
TPS1.1A LA
8. Alignments
8. Alignments
Index of this chapter:
8.1 Electrical Instructions
8.2 ISP Instructions
8.3 Serial Number Definition
Notes: You could adjust the LCD/TV following this chapter when the LCD/TV has the below defect.
1. Change panel. 2. Change or repair main board. 3. LCD/TV color is not right. 4. The settings are disabled.
8.1.1
TV mode display adjustment
8.1.1.1
White balance adjustment (B)
8.1.2
PC Mode Adjustment
8.1.2.1
White balance adjustment (B)
8.1
Electrical Instructions
General set-up:
Equipment Requirements: Color analyzer.
Input requirements:
Input Signal Type
: RF signal
Set to PAL D/K system, frequency=184.25MHz ( for China
model ) with white pattern of 100%
Input Signal Strength : 10mV (80 dBuV) terminal voltage.
Input Injection Point : TV Tuner input
Initial Set-up
: Apply full white pattern, select smart setting to be PERSONAL (Brightness 50,
Contrast 50, and Color 50). Adjusting SCALER GAIN R G B to reach W/D
and luminance in factory mode as below.
Select Color Temp in the factory Mode OSD.
The 1931 CIE chromaticity (X, Y) co-ordinates shall be:
Alignment
: Adjust the factory "CLR_TEMP_R / CLR_TEMP_G / CLR_TEMP_B"
To met NORMAL, COOL and WARM color temperature requiremet.
[ Enter factory key 062596 by remoted number key]
Output Detection Points : Screen center.
Color Temp
x
y
Normal
0.291
±
0.005
0.302
±
0.005
Warm
0.314
±
0.005
0.324
±
0.005
Cool
0.273
±
0.005
0.280
±
0.005
If you have not CA-210, the following R,G and B values are for your reference.
Color
Temp
R
G
B
Normal
122
122
122
Warm
124
124
120
Cool
120
120
124
General set-up :
Equipment Requirements: PC signal / Color analyzer.
Input requirements:
Input Signal Type
: PC R/G/B analog TTL separate Sync signal.
Timing = 1024x768/60Hz.
Input Signal Strength : 700mV.
Input Injection Point : D-Sub
http://jdwxzlw.5d6d.com/?fromuser=森林
家电维修资料网
免费下载各种维修资料
