17
English
4 Use your TV
Switching on your TV and putting it in
Standby mode
To Turn the TV On from Standby or Off to Standby
•
Press (3 raised dots on the Rear panel or Front panel or the
Remote control).
Adjusting volume
To decrease or increase volume
•
Press
VOL
ɿ
/
ɽ
(1 raised dot on the Rear panel or Front panel)
or press
VOL + /
ñ
on the Remote control.
VOL
ɿ
: Volume Down
VOL
ɽ
: Volume Up
To mute or unmute sound
•
Press
on the remote control to mute the sound.
•
Press
again
or
VOL + /
ñ
to recover the original sound.
Switching channels
To select Channels by using CH
ɾ
/
ɼ
or CH + /
ñ
•
Press
CH
ɾ
(Down) /
ɼ
(Up - 1 raised dot on the Rear panel or
Front panel) or press
CH + /
ñ
on the Remote control.
To select Channels by using the NUMBER buttons
•
For Digital channels, press a number followed by a dot “•” and the
corresponding sub channel number.
–
When selecting Digital channel 11.1
Be sure to press • before entering the subchannel number.
–
When selecting cable or Analog channel 11
Press
PREV.CH
to return to the previously viewed channel.
* On the 46” & 50” TV’s All CONTROL Keys are located on the Rear
(lower right) side of the unit as viewed from the Front.
Note
• Energy consumption contributes to air and water pollution. When the AC power cord
is plugged in, your TV consumes energy. Your TV has very low standby power
consumption.
39PFL3708
32PFL3508
39PFL3708
32PFL3508
Note
• To select the non-memorized channels, use
the NUMBER buttons
.
•
No Signal
will appear on the TV screen after the subchannel broadcast is over.
•
Audio only program
message will appear on the TV screen, when you receive only
sound signal.
39PFL3708
32PFL3508
Digital TV operation
Analog/Cable TV operation
