Mechanical Instructions
4.
4.6.6
IR/LED Board
Refer to
for details.
1.
Remove the fixation screws [1] from the stand bracket, pull
out the assy from the set. Refer to
for details.
2.
Carefully Releas the cover secured by clips, then unplug
the connector [2] from the IR/LED board. The IR/LED
Board can now be lifted and taken out from the cover. Refer
to
for details.
Figure 4-31 IR/LED Board removal
4.6.7
Power Supply Unit (PSU)
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the PSU.
1.
Unplug all connectors from the PSU.
2.
Remove all fixation screws from the PSU.
3.
The PSU can be taken out of the set now.
4.6.8
Speakers
1.
Gently release the tapes that secures the speaker cables.
2.
Unplug the speaker connectors from the SSB.
3.
Take the speakers out.
When defective, replace the both units.
4.6.9
LCD Panel
1.
Unplug the all the connector cables of the boards.
2.
Lift the subframe with PSU, SSB, FRC board, Keyboard
control panel, IR/LED board and AmbiLight control panel
from the LCD panel and put it aside.
3.
Gently take all the speakers out.
Warning: Cause the panels of 6300 series are bolt-on panels
so the panel could not release from bezel.
When defective, replace the whole unit.
19792_108.eps
2
1
1
