Mechanical Instructions
4.
4.3.4
Speakers
1.
Unlug the connector from SSB.
2.
Release the cables from their clamps(28”, 32”, 40”).
3.
Release the tapes which fixate the cabling.
4.
Take the speakers out.
When defective, replace the both units.
4.3.5
Power Supply Unit (PSU)
Caution:
it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the PSU.
1.
Release the Power board cables from their clamps.
2.
Unplug power connectors from the SSB, as it is not
unplug-able at the PSU itself (soldered connector).
3.
Unplug all other connectors from the PSU.
4.
Remove all fixation screws from the PSU.
5.
The PSU can be taken out of the set now.
4.3.6
Small Signal Board (SSB)
Caution:
it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the SSB.
1.
Pull the upper part of the connector, which fixes the LVDS
cable to the connector, from both sides up a little bit.
Release the LVDS cable from its connector by pulling it up
slowly.
Release the LVDS cable from its connector on the SSB by
pressing the clips on both sides and pulling it out slowly (for
40”).
Caution:
Be careful, as these are very fragile connectors!
2.
Release the clamps and unplug all other connectors.
3.
Remove all other fixation screws from the SSB.
4.
The SSB can be taken out of the set now.
4.3.7
IR/LED Board
1.
Unplug the connector that connects the board with the
SSB.
2.
Release the clamps and/or tapes that hold the boards
cable.
3.
Remove the fixation screws on the protective cover and/or
on the board itself.
4.
The IR/LED board can be taken out now.
When defective, replace the whole unit.
4.3.8
LCD Panel
1.
Remove the SSB as described earlier.
2.
Remove the PSU as described earlier.
3.
Remove the speakers and the IR/LED board as described
earlier (if necessary).
4.
Release the clips (if necessary), that secure the LCD Panel
with the bezel.
5.
Lift the LCD Panel from the bezel.
6.
Release the clips from both sides of the LVDS Flat Foil
connector that connect to the LCD panel.
Caution:
Be careful, as these are very fragile connectors!
When defective, replace the whole unit.
4.4
Set Re-assembly
To re-assemble the whole set, execute all processes in reverse
order.
Notes:
•
While re-assembling, make sure that all cables are placed
and connected in their original position. See
or
for 28” model.
•
Pay special attention not to damage the EMC foams on the
SSB shields. Ensure that EMC foams are mounted
correctly(If available).
