Philips 170C4FS/00, Service Manual

Page: 9 / 66

170C4/N4
9
Go to cover page
Factory mode
Access Factory Mode
Step 2 :
[Push AUTO " " & OK " " buttons at the same time and hold
it ] + [Press power " " button untill comes out "Windows screen"
] => then release all buttons.
How to Get into Factory Mode Menu
Turn off monitor.
Press OK " " button, bring up Factory mode indication as
shown in Fig 2.
Step 1 :
Step 3 :
Basic and simple instruction on the control keys.
When you press the button on the front control of your monitor, the On-
Screen Display (OSD) Main Controls window will pop up and you can
then start making adjustments to your monitor's various features.
Front control panel
Fig. 1
Fig. 2
Contrast adjustment (Sub-Contrast). Use this menu item to
adjust the contrast gain of pre-amp ranges from 0 to 255.
9 3 0 0 K R G B
6 5 0 0 K R G B
Color temperature gain adjustment. Use these menu items to
adjust the RGB gains of pre-amp for different color
temperatures, ranges from 0 to 255.
OFFSET R G B
Sub-Brightness adjustment. Use this menu item to adjust
the brightness level (DC-level) of pre-amp range from 0 to
255.(R/G/B ANALOG DC -level).
GAIN R G B
R/G/B GAIN adjustment. Use this menu item to adjust
the R/G/B (GAIN) of Amp. range from 0 to 255.(R/G/B
ANALOG GAIN Values).
It is for 1024x768/60Hz with special pattern only.
AUTO SUB:
Do not use this function here.
AUTO SUB:
(PS: The Offset R G B function can be used on reduce or eliminate
snowy noise on the background when the resolution of video signal is
1280 X 1024 vertical 60Hz. Slightly increase or decrease the value
until snowy noise completely disappear.)
Hot key function: by pressing "UP" and "DOWN" key
simultaneously at User mode (or Factory mode).
-
OK
-
SUB CON: SUB CON:
HUDSON3 170C4 V200 2003010
<------ Factory mode indicator
BL : Blacklevel value
SUB-BRI : Brightness value range(Min Max)
SUB-CON : Contrast value range(Min Mid Max)
SRGB-B : Brightness of sRGB
SRGB-C : Contrast of sRGB
Gain-m : Minimum value of User Gain
Gain-M : Maximum value of User Gain
AUTO-SUB : To do Auto color function
When push Menu key in white pattern
OSDTIMER : OSD time out control(sec)
VCON
: For LG 15inch panel control
IDX : Limit current of inverter
(For 15inch panel control)
SCALER : Read/Write scaler register
NVRAM : Read/Write eeprom address
Panel : AUO (AUO panel)
CPT (CPT panel)
QDI (QDI panel)
LPL (LG.Philips panel)
Factory menu
Cursor can move on gray color area
Fig. 3
http://www.wjel.net