Philco PDT 67 DF, Owner'S Manual

Page: 12 / 180

Copyright © 2020, Fast ČR, a. s. Revision 10/2021
EN - 10
Spray arm
It is necessary to clean the spray arm regularly for hard water chemicals will clog the spray arm jets and
bearings.
To clean the spray arm, follow the instructions below:
1 To remove the spray arm, pull out the
spray arm upward.
2 Wash the spray arm in soapy and warm
water and use a soft brush to clean the
jets. Replace them after rinsing them
thoroughly.
Caring For The Dishwasher
Frost precaution
Please take frost protection measures on the dishwasher in winter. Every after washing cycles, please operate
as follows:
1. Cut off the electrical power to the dishwasher at the supply source.
2. Turn off the water supply and disconnect the water inlet pipe from the water valve.
3. Drain the water from the inlet pipe and water valve. (Use a pan to gather the water)
4. Reconnect the water inlet pipe to the water valve.
5. Remove the filter at the bottom of the tub and use a sponge to soak up water in the sump.
After every wash
After every wash, turn off the water supply to the appliance and leave the door slightly open for a while so that
moisture and odors are not trapped inside.
Remove the plug
Before cleaning or performing maintenance, always remove the plug from the socket.