PART NO.: 6441-727A
1
REPAIR PROCEDURES: SERIES GRF DESIGN 2 [6] GRIPPERS
PHD, Inc. makes no warranty as to the fitness of its products or as to the length of service life after being repaired or parts replaced by anyone other than authorized
employees of PHD, Inc. In no event shall PHD, Inc. be liable for loss of profits, indirect, consequential, or incidental damages arising out of the use of PHD Products.
BEARING PLUGS
FIGURE 4
GRF34-x-25 x 6.5
JAW COVER
JAW
BODY ASSEMBLY
BORE PLUG
TARGET PIN THREAD
ALIGN WITH TARGET SLOT
CAM DRIVER
ALIGN SENSOR COVER WITH EDGE
(SIZE 25 & 28)
CENTER OVER MAGNET TARGET SLOT
(SIZE 19 & 32)
PROX TARGET PIN
(OPTION CP ONLY)
OPTIONAL
PROX TARGET
AND SET SCREW
SENSOR
COVER
MAGNET
TARGET PIN
MAGNET TARGET
ASSEMBLY
ROD SEAL
(SEE FIGURE 2)
PISTON
(EXCEPT SIZE 19)
PISTON SEAL
PISTON ASSEMBLY FASTENER
(EXCEPT SIZE 19)
BORE PLUG SEAL
BORE PLUG RETAINER
JAW COVER ASSEMBLY FASTENERS
QTY 4 ON SIZES 19, 25 & 28
QTY 8 ON SIZE 32
ROD
(EXCEPT SIZE 19)
FIGURE 3
SIZE 19 ONLY
REPLACES ROD,
PISTON, AND PISTON
ASSEMBLY FASTENER
JAW SLOT
FIGURE 5
JAW
TARGET SLOT
APPROXIMATELY
0.04 in [1 mm]
SENSOR
COVER SLOT
MAGNET
TARGET PIN
MAGNET TARGET
ASSEMBLY
SENSOR
COVER
JAW DRIVER
BORE PLUG
PISTON
FIGURE 2
JAW DRIVER
COUNTERBORE
JAW
ROD SEAL
NOTE ORIENTATION
PISTON SEAL
BORE PLUG SEAL
(SNAPS INTO GROOVE IN
BORE PLUG ON SIZES 19 & 25)
BORE PLUG
RETAINER
FIGURE 1
