Phason Supra Touch Series, Manual, Page: 66 / 98

Phason 66 / 98 34740001
Equipment icons
Variable cooling Variable heating
Relay cooling Relay heating
Relay cooling duty cycle Relay heating duty cycles
Relay follow variable cooling Relay follow variable heating
Relay follow relay cooling Relay follow a relay heating
Actuator / inlet with feedback Curtain / inlet without feedback
Air curtain
Sensor icons
Temperature Humidity
Ammonia Carbon dioxide
Light Water meter
Wind speed
Widgets
Pressing the widget button in the center of the status screen takes you to the widget screen for the selected
sensor or piece of equipment. Widget screens allow you to do some of the following, depending on the type
of sensor or equipment:

Switch between automatic and manual control

Go to settings, modifiers, and alarms screens for the sensor or equipment.

Calibrate and unjam actuators.

View the current day’s high and low readings for sensors.
Acknowledging alarms
An alarm occurs if an enabled alarm condition is present for longer than the minimum duration of one
minute. The one-minute minimum duration prevents alarms from occurring when the temperature rises or
falls or just a few seconds. The exceptions to the one minute minimum are the actuator jam alarms.
Actuator jam alarms activate 20 seconds after the alarm is detected.
When an alarm occurs, the alarm relay triggers (switches) and a message flashes on the screen.