Phase AxN, User Manual

Page: 45 / 60

AxN Configurable Motion Control Platform
44
4.4.8 S1 Connector
——
Serial Bus Port
AxN 09.20.4 Drive’s Serial Bus Port (S1) supports RS-232, RS-422, RS-485 and CAN protocol. But
only one communication interface can be used at a time.
Port Location
AxN 09.20.4 Drive’s Serial Bus Port (Male Plug, 9 Pin D-Sub) is on the downside of drive‘s
communication port panel. Refer to the following figures for exact location.
4.4.9 RS-232
Pin Assignment
Pin Standard RS-232 AxN RS-232 Function
1 DCD --- Data Carrier Detect
2 RXD RXD Received Data
3 TXD TXD Transmitted Data
4 DTR DTR Data Terminal Ready
5 GND GND Common Ground
6 DSR DSR Data Set Ready
7 RTS RTS Request To Send
8 CTS CTS Clear To Send
9 RI --- Ring Indicator
Notes:
1. RS-232 devices may be classified as Data Terminal Equipment (DTE) or Data Communication
Equipment (DCE); this defines at each device which wires will be sending and receiving each
signal. AxN 09.20.4 Drive is a Data Communication Equipment (DCE), and a controller or a
computer is a Data Terminal Equipment (DTE).