phase II+ UTG-400, Manual, Page: 7 / 22

3.2 PRESET OTHER SPECIFICATIONS
Press “ M ” to enter the user interface, which allows you to select and adjust options like VIEW
MODE, PROBE SETUP, MINIMUM ALARM, MAXIMUM ALARM, NORMAL THICKNESS, MINIMUM of
B‐SCAN, MAXIMUM of B‐SCAN, RECTIFICATION, RECTIFICATION WAVEFORM, RESOLUTION,
LANGUAGE, UPDATE RATES, UNITS, AND DEFAULT SETUP. See the following figure:
3.2 Menu Selections
VIEW MODE: normal mode, difference mode and limit scanning mode.
PROBE SETUP: PT‐10/PT‐08(normal probe), PT‐06(small probe), PT‐04(mini probe), GT‐12(high‐temperature
probe), and ZT‐12 (cast iron probe).
MINIMUM ALARM : set the minimum thickness alarm value. The result will be displayed in red if the actual
thickness is less than the minimum value preset.
MAXIMUM ALARM : set the maximum thickness alarm value. The result will be displayed in red if the actual
thickness is more than the maximum value preset.
NORMAL THICKNESS: set the normal thickness. The real concrete application will be introduced in the
DIFFERENCE MODE .
MINIMUM of B ‐ SCAN : set minimum thickness for B‐scan
MAXIMUM of B ‐ SCAN : set maximum thickness for B‐scan
RECTIFICATION MODE: RF, full wave, half ‐, half +. RF describes the complete echo waveform; full wave
indicates the half + echo and the overturned half ‐ echo; half – means putting off the half + echo and turn the half
– over to +; half + means putting off the half – echo and only left the half + echo.
RECTIFICATION WAVEFORM: outline mode and fill mode.
RESOLUTION:
Selectable Resolution: 0.001”, 0.01” or .01mm
LANGUAGE: the interface language: Chinese or English
.