PG Drives Technology VR2 series, Operation And Installation Manual

Page: 143 / 152

PG
DRIVES TECHNOLOGY
131
C
HAPTER
7 - W
ARNING
S
UMMARY
SK77898/2
Ensure that the charger plug pins are of the correct polarity
to be compatible with the pin polarity shown on the control
system’s specific data sheet. Failure to observe this condition
could result in a burn hazard or fire hazard. PGDT accepts
no liability for losses of any kind arising from failure to
comply with this condition.
Do not disconnect batteries or open-circuit the circuit breaker
while charging is in progress. Failure to observe this
condition could result in a burns hazard or fire hazard.
PGDT accepts no liability for losses of any kind arising
from failure to comply with this condition. Chapter 2 section
8.1.
2.16 On-board Charging
Do not exceed the maximum charging current of 12 A rms.
Always use an on-board charger sitted with the Intech parts
specified in section 4.3. PGDT accepts no liability for losses
of any kind arising from failure to comply with this condition.
Ensure that the charger plug pins are of the correct polarity
to be compatible with the pin polarity shown on the control
system’s specific data sheet. Failure to observe this condition
could result in a burn hazard or fire hazard. PGDT accepts
no liability for losses of any kind arising from failure to
comply with this condition.
Do not disconnect batteries or open-circuit the circuit breaker
while charging is in progress. Failure to observe this
condition could result in a burns hazard or fire hazard.
PGDT accepts no liability for losses of any kind arising
from failure to comply with this condition. Chapter 2 section
8.2.
2.17 Production Test
These tests should be conducted in an open space and a
restraining device such as a seat belt should always be
used. PGDT accepts no liability for losses of any kind arising
from failure to comply with this condition. Chapter 2 section
11.