Operating Instructions
Contador
© 2019 – Pfeuffer GmbH
Revision 6
Page 19 of 40
6
Installation and operation
The Installation and operation chapter is intended only for
specialists
.
6.1
Assembling the CONTADOR
Carefully unpack the CONTADOR with the usual care and position it horizontally.
A correct, horizontal assembly of the machine guarantees an even distribution of the
seeds in the outlet channel.
Check all components for tightness.
The CONTADOR exerts vibration forces on the base. Do not set up the CONTADOR close to
apparatus/devices that are sensitive to vibration
Avoid exposure to direct sunlight and extreme ambient conditions.
Make sure that the installation height is ergonomic according to the stature of the operating
personnel.
Connect the supplied mains cable to the CONTADOR using the connector (C19/C20 coupler).
Connect the plug of the mains cable to a suitably earthed socked with protective
earth conductor.
Position a feed container on the seed counter.
Insert the drawer (without CONTAFILL).
Switch the CONTADOR on at the mains switch (position
I
).
Observe the information concerning operation in
chapter 7.
6.2
Assembling with the CONTAFILL semi-automatic filling station (optional)
Disconnect the mains plug of the CONTADOR Seed counter before you start
assembling.
Remove the drawer of the CONTADOR Seed counter.
Place the CONTADOR on the semi-automatic filling station CONTAFILL so that the CONTADOR rubber
feet sit exactly in the foot rests of the CONTAFILL.
Connect the CONTAFILL to the CONTADOR using the 15-pin D-sub connection cable, see also
chapter
Figure 9: Put on CONTADOR and connect with CONTAFILL
