Operating instructions PY L-S
03/2021
Page 5 / 7
086200015b
en
6.2
Electrical connection
Observe the
Circuit board in lower part:
PY L-S with single color LED
Connecting cables:
PY L-S with multicolor LED (RGBW)
Note
: Devices with DC voltage are equipped with reverse polarity protection. No function if the polarity of the
connections is reversed.
7.1 Setting the operating modes - versions with single-color LED (without external control)
Circuit board in the lens:
S1
Selection of
operating mode
Light intensity control
Flashing light: 10 – 100%
Blinking- / Continuous light:
45 – 100%
S1
Operating mode
*
Factory setting
1
2
3
OFF OFF OFF
Flashing light 1 Hz
*
OFF OFF ON
Flashing light 0.75 Hz
OFF ON OFF
Continuous light
OFF ON ON
Blinking light 1 Hz
ON OFF OFF
Flashing light 2 Hz
ON OFF ON
Blinking light 2 Hz
ON ON OFF
Flashing light 0.1 Hz
ON ON ON
Flashing light 0.5 Hz
OFF OFF ON
Double Flash mode (DFM3) see
Operating voltage
connection
AC:
DC
:
Operating voltage
connection
AC:
DC
:
