Smart Toolbox on Embroidery Area
The Smart Toolbox is available in the sewing and
embroidery area. Touch & hold anywhere in your work
area to open the Smart Toolbox and select the option
you want.
The options included in the Smart Toolbox differs
depending on where it is used. Examples of options are
Reset Toolbar, Open Help Center and Move Into Hoop.
Move Into Hoop
A red frame will surround the embroidery area if a
design is placed outside the hoop area. Select Move Into
Hoop to move any design that is outside the hoop area
into the hoop area. The design will be placed at the
outermost edge of the hoop.
Tip: If you want to place a design e.g. in the top left corner as
near as possible easily, touch and drag your design to the top
left corner. Make sure that the design is placed outside the
hoop area. Touch Move into Hoop and the design will be
placed at the top left corner of the hoop area, as close to the
hoop edge as possible.
Grid On/Off
Use the grid as a guide when you combine or place
designs.
You can set the distance between the grid lines in
millimeter or inch by entering a number in the keypad.
Touch to open Hoop Options and activate/deactivate
grid.
Note: Touch & hold on the Embroidery Area to open the
Smart Toolbox and select Grid On/Off.
Delete All
Select to delete all loaded designs from the embroidery
area. Touch OK in the pop-up message to confirm.
Read about Embroidery Edit
Select to open the User’s Guide to read about the
Embroidery Edit.
Reset Toolbar
Select if you want to reset your Toolbar to default.
Read about customizing your work area.
124