Sealing
41
10
.05.05
Entering further sealing parameters
Further sealing parameters can be entered either
- from the Manual Sealing mode in conjunction with the sealing speed input or
- when creating programs in conjunction with the input of the first zone..
Input from manual/dynamic
sealing mode
Input during
program creation
Select acceleration and brake profile of the feed rollers, dependent on the material for
sealing. Each of the profiles selected is displayed as an inverse symbol. A flat ramp
stands for slight acceleration of the feed rollers. The selection of a steep ramp means
high acceleration.
If the sealing result is unsatisfactory, the alteration of the acceleration or brake
profile can lead to an improvement.
The values of the different acceleration and brake profiles can be stipulated in
the input mode, see Chapter
11.03.02 Feed roller parameters
.
Increase or reduce the start delay for the feed rollers directly.
or
Call up the figure panel to enter the start delay.
Using the number block, enter the start delay time depending on the work material.
Conclude the input, permissible values will be taken over.
The start delay function is used to stipulate the amount of time which should
pass between the engaging of the heating element and the start of the feed rol-
lers.
●
●
●
●
●