PEUGEOT PARTNER 2016, Handbook, Page: 150 / 260

148
Partner-2-VU_en_Chap08_Aide-rapide_ed02-2016
Snow screen
REMOVABLE SNOW SCREEN
(BLANKING COVER)
According to country, the removable
snow screen is installed on the lower
part of the front bumper to prevent the
accumulation of snow at the radiator
cooling fan.
Do not forget to remove the snow
screen when the exterior temperature
is higher than 10°C (no risk of snowfall)
and when towing.
Fitting
Removal
- Pass a screwdriver into the hole
located near each of the clips.
- Use the screwdriver as a lever to
unclip the four clips
B in turn.
- Offer up the snow screen facing its
centring pin
A on the front bumper.
- Put it in place by pressing at each
clip
B located in the four corners.
6. Refitting the repaired wheel
The wheel is refitted as described in
step 5, not forgetting to refit the wheel
trim.
Refer to the "Identification
markings" section of chapter 9 to
locate the tyre label.
Refer to the "Instruments and
controls" section of chapter 3,
"Tyre under-inflation detection"
part, for recommendations after
changing a wheel fitted with a tyre
under-inflation detection sensor.