PEUGEOT 208 2017, Handbook

Page: 28 / 304

26
Dashboard instruments
Resetting the service indicator Retrieving the service
information
After each service, the service indicator must
be reset to zero.
If you have carried out the service on your
vehicle yourself:
F
switch off the ignition,
If you have to disconnect the battery
following this operation, lock the vehicle
and wait at least 5 minutes for the reset to
be registered.
F
press and hold the trip distance recorder
reset button,
F
switch on the ignition; the distance recorder
display begins a countdown,
F
when the display indicates " =0 ", release
the button; the spanner disappears.
You can access the service information at any
time.
F
Press the trip distance recorder reset
button.
The service information is displayed for a few
seconds, then disappears.
Engine oil level indicator
(depending on version)
On versions fitted with an electric oil level
indicator, the state of the engine oil level is
displayed in the instrument panel for a few
seconds, after the servicing information.
The level read will only be correct if the
vehicle is on level ground and the engine
has been off for more than 30 minutes.
Oil level incorrect
This is indicated by the display of the message
"Oil level incorrect" in the instrument panel
screen, accompanied by the service warning
lamp and an audible signal.
If the low oil level is confirmed by a check using
the dipstick, the level must be topped up to
avoid damage to the engine.
For more information on
Checking levels ,
refer to the corresponding section.
Oil level indicator fault
This is signalled by the display of the message
"Oil level measurement invalid" in the
instrument panel.
Contact a PEUGEOT dealer or a qualified
workshop.