TECHNICAL SPECIFICATIONS
U2WR
Via Pianelli,38 - 28017 S.Maurizio d’Opaglio (NO) ITALY Tel. +39 0322 96217 - Fax. +39 0322 96546 - www.pettinaroli.com
S
T
E
01
6
4
re
v.
0
0
0
4
/1
1
/2
0
1
5
REPEATER
U2WR
The repeater
U2WR
extends the radio range of the wireless
control units
U2W
in order to reach also the furthest
thermostats.
The repeater can be coupled only with the following products:
U2W404/ U2W408/ U2W412
U2W4E04/ U2W4E08/ U2W4E12
U2W204/ U2W208/ U2W212
U2W2E04/ U2W2E08/ U2W2E12
Every other use is considered as not intended and the
manufacturer warranty is not more valid.
-----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
TECHNICAL DATA
Type
U2WA
APPROVALS
Operating voltage
5 V via power supply
EN 60730/1
Power consumption
<1 W
Operating frequency
868 MHz SRD band
Degree/Class of protection
IP30 / III
Range
>25 m inside buildings
Ambient temperature
0°C to 55°C
Storage temperature
-25°C to +70°C
Air humidity
max. 80%
1
Dimensions (mm)
76/76/35
Weight
115 g
Length of connection cable
1,5 m
1 – non condensing
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
INSTALLATION
Direct pairing procedure of non-receiving room thermostat to the wireless control unit and wall installation:
1.
Open the repeater with a flat screwdriver.
2.
Insert the cable of the power supply into the housing from the back
3.
Install the repeater
4.
Connect the repeater to the power supply, put the jack into the specific socket
5.
Close the repeater cover
6.
Power the repeater, putting the main plug into a house socket. The green LED are lighted
7.
Active the pairing mode on the repeater pushing the button for more than 5s. The green LED starts flashing
8.
Perform the radio test on the room thermostat. The green and yellow LED are lighted
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
