12
1-800-732-2677
The Receiver Collar
is beeping but my
pet is not responding
to the Static
Correction.
Make sure the Static Correction Level is set at 2 or above.
•
Test the Receiver Collar with the Test Light.
•
If the Test Light fl ashes, check the fi t of the Receiver Collar.
•
Trim your pet’s fur where the Contact Points touch the
•
neck and/or purchase long Contact Points by contacting the
Customer Care Center at 1-800-732-2677.
Increase the Static Correction Level.
•
Repeat training steps to reinforce training.
•
My pet reacts
strongly to the Static
Correction and has
become fearful.
Lower the Static Correction Level.
•
Make sure you are in control of the situation when your pet
•
receives his fi rst Static Corrections (have him on a leash attached
to a separate, non-metallic collar) and lead him into the Pet Area
and praise him. If your pet remains fearful, suspend training and
start again the next day. Make sure to end all training sessions on
a positive note with lots of praise and play.
I was setting up the
Pet Area and after
I turned down the
Boundary Control
Dial, the Receiver
Collar would no longer
beep or correct.
You may have turned the Boundary Control Dial down too
•
quickly, causing the Receiver Collar to go into power-fail
mode. This is a safety feature designed to protect your pet
when power to the Transmitter goes out. With the Receiver
Collar within 5 feet of the Transmitter, turn the Boundary
Control Dial to “8” and reset the Boundary Zone, making
sure to turn the dial down slowly.
Summary of Contents for Wireless Pet Containment System Receiver Collar
Page 18: ...18 1 800 732 2677...
Page 19: ...www petsafe net 19...
