Petsafe PBC64-15535, Operating Manual

Page: 22 / 29

中文
EN
22
Customer Care 86 (0) 755 2671 5353
What to Expect During Use of the Bark Control Collar
Important:
Do not leave your dog alone the first few times he receives a static correction.
Place the Bark Control Collar properly on your dog and wait nearby until he barks. Most dogs will
understand very quickly that the Bark Control Collar is disrupting their urge to bark and will relax and
stop barking. Some dogs will bark more, and as the static correction from the Bark Control Collar may
be surprising or startling, some dogs may vocalize in response to the initial correction.
On rare occasions, a dog may get into a bark-correction-bark-correction cycle that could be quite
overwhelming. If this happens, reassure your dog with calm, soothing tones. As your dog relaxes, he will
understand that if he becomes quiet, he will not receive any more static corrections. The small minority of
dogs that have this reaction will only have it the first time they wear the Bark Control Collar.
You should notice a reduction in your dog’s barking within the first couple of days that he wears the
Bark Control Collar. At this point, some dog owners feel that the problem has been solved, but in most
cases the learning process is still not complete. Most dogs will “test” this new learning experience and
will increase their attempts to bark. This usually occurs during the second week a dog wears the Bark
Control Collar. If this does occur, remain consistent and do not alter your use of the Bark Control Collar.
You must place the Bark Control Collar on your dog in every situation when you expect him to be quiet.
If your dog is not wearing the Bark Control Collar, he may resume barking and his learning would suffer
a setback.
Regular Maintenance
• Check Contact Points for tightness weekly.
Note: Do not adjust the factory preset Sensor Probe.
• Clean Contact Points weekly.
• Check your dog’s neck for irritation and wash neck weekly.
To Test the Bark Control Collar
Slide the Sensor Probe across a rough surface for at least 25 cm. The
Bark Control Collar should beep. If your Bark Control Collar doesn’t
beep during this test, see “The Bark Control Collar does not beep” in the
"Troubleshooting" section, and continue with the second step.
BATT
ERY
6V
RFA-67