3
2.1.
Programming firing modes
Programming firing modes – enter the programming mode for “SEMI” or “AUTO” selector
position and
pull the trigger 0 to 6 times
, then hold the trigger until a sound signal can be
heard to save the settings.
Perun V3 allows the mechanical trigger lock to be retained. Because of that, with selector in
“SAFE” position the replica will always remain safe (provided that the mechanical lock works
properly). On both other selector settings („SEMI” and „AUTO”) any firing mode can be set,
independently.
For example, to change firing mode for selector in “SEMI” position, quickly switch from
“SEMI” to “AUTO” and back to “SEMI” twice. Entering the programming mode will be
confirmed by a sound signal.
After entering the programming mode choose firing mode:
Safe – save changes right after entering the programming mode.
Single shot (semi) – pull the trigger once.
2-5 round burst – pull the trigger 2-5 times.
Full auto – press the trigger 6 times.
Save changes by pulling and holding the trigger until a sound signal can be heard. All the
changes will be stored in memory and valid also after disconnecting and connecting the
battery again.
2.2.
Active brake (AB)
Active brake – enter programming mode for any selector position,
pull the trigger 7 times
,
and hold the trigger until a sound signal can be heard to save the settings.
Active break (AB) is a feature, which if enabled, stops the motor after each shot (in single fire
mode) or after the last shot of a burst. This prevents main spring from remaining
compressed and in case of replicas with lower muzzle energy and high rate of fire, prevents
the problem of unwanted double shots in single fire mode.
Note that the use of active brake makes the motor heat up faster and accelerates wear of
motor brushes. Therefore it is recommended to only keep AB on, if it is necessary. If not, it is
much better to turn it on only at the end of the day, to fire just a few shots in single fire
mode, so that the spring will remain uncompressed during storage.
While precocking is enabled, the AB setting is irrelevant.
