Permobil Stander, Service Manual, Page: 33 / 47

34
Repairs
5. Remove the rubber protection that covers the
limit switch kit. Loosen the screw on the lower
end position switch (Fig. 81:1) and adjust
the switch so that the stand function actuator
extends a further 2 mm. This adjustment must
be sufficient to keep the frame prestressed.
Then tighten the screw to lock the switch in
the new position.
Fig. 82. Raising must stop at 75°.
Fig. 81. Lower and upper end position switches.
1
2
6. Loosen the screw on the upper end position
switch (Fig. 81:2). Adjust the position of the
switch untill the raising stops at 75°, see fig. 82.
7. Refit the rubber protection on the limit switch
kit and remove the tape from the switch on the
seat lift.
8. Lower the seat lift to its lowest position.