Permobil Stander, Service Manual, Page: 30 / 47

Repairs
31
Fig. 71. The angle stop is mounted on the
back side of the backrest.
Replacement of angle stop
An angle stop is mounted on the backrest. The
angle stop causes the backrest to never be able
to be angled down at more than 90°.
Removal
1. Run the seat up to the standing position.
2. Set the Circuit breaker for the chassis to the
”OFF” position. For more information, see the
chassis service manual.
3. Remove the angle stop. It is mounted using
two screws, see Fig. 72.
4. Follow the cable to the seat function board.
Cut the wiring bundle tie holding the cable.
Take note of the cable's connection and
routing for purposes of later remounting.
Fitting
Mounting is performed in the reverse order. The
angle stop is always mounted with an angle of 90°,
see Fig. 74.
Fig. 72. The angle stop is mounted
using two screws.
Fig. 74. The angle stop must be
mounted with an angle of 90°
Fig. 73. Seat function board.
90°
60°
30°