Permobil Stander, Service Manual, Page: 14 / 47

15
Adjustments
1. Unscrew and remove the support wheels. On
seats equipped for stand-up driving, they are
mounted using two screws on each side of the
leg rest, see Fig. 22. On seats without stand-up
driving, they are mounted on the rear edge of
the foot plate, see Fig. 23.
2. Unscrew and remove the knee rest. It is
mounted with a screw, see Fig. 24:1.
3. Unscrew and remove the six screws holding
the foot plate, see Fig. 24:2.
4. Unscrew and remove the calf rest's bracket. It
is mounted using two screws on the back side
of the leg rest, see Fig. 25.
5. Loosen the two locking screws on the foot
plate, see Fig. 21.
6. Remove, turn the bracket upside down and
remount in reverse order.
Setting the Angle
The angle of the foot plate can be adjusted by
screwing the nuts on the foot plate's adjustment
screws in or out, see Fig. 26.
Fig. 26. Setting the angle of the foot plate.
Fig. 24. Fastening screws for the knee rest
and foot plate.
1
2
Fig. 25. The calf rest is mounted with two screws.
2
After making an adjustment, always be sure to tighten
the two locking nuts for the slope adjustment, in order to
lock the setting.

NOTE