ROHO AGILITY CARBON Contour Back Support Operation Manual
8
Angle Adjustment
Follow these instructions for left and right sides.
Warnings:
-
DO NOT adjust the angle while the product is installed on the wheelchair. If the product is installed, first remove it from the wheelchair
before adjusting the angle. See "Product Removal".
-
DO NOT install, remove, or adjust the angle of the product while the individual is seated in the wheelchair.
1. Before adjusting the angle, make sure the hardware
is correct for the wheelchair and back shell. See
"Hardware Selection".
2. Loosen the angle adjustment screw up to 1½ full
rotations.
Warning: If you rotate the angle
adjustment screw too far, and it comes
out, see "Hardware Attachment."
3. On each side of the back shell, locate the markers and
rotate the hardware to the desired angle.
Make sure that the markers are lined up the same way
on both sides.
Note: Each back shell marker represents 5 degrees.
The angle can be adjusted up to 15 degrees in either
direction.
One marker on each
inner cane clamp
Markers on
each side of
the back shell
L
R
4. Tighten the angle adjustment screw until snug.
Note: If a torque wrench is available, tighten to no more
than 60 inch-pounds (7 Newton-meters).