Permobil M400 Corpus HD, Service Manual, Page: 71 / 100

M400 Corpus HD
Repairs - Control panel and electronics
4.3.1.2 Mounting R-net control panel
Figure 107. The control panel is held in place by two
screws on the rotational panel holder.
Figure 108. The control panel is held in place by two
screws on the parallel panel holder.
1. Assemble the R-net control panel (A). It is held in place by two
screws. The same two screws also fasten the bracket for the ICS
control panel (B). Be sure not to over tighten the screw.
2. Reconnect the R-net control panel cable connector.
3. Use cable ties to secure the cabling from the R-net control panel
(A) and the ICS control panel (B). Use the same mounting points
for the cable ties that were used before the cables were disassembled.
Figure 109. On/Off symbol depending on model.
4. Switch On the main power switch on the control panel.
4.3.2 R-net power module
The following tools are necessary for this task:
• Wrench 8 mm
4.3.2.1 Removing R-net power module
1. Switch off the main power switch on the control panel.
2. Switch the main fuse to OFF. See 4.3.4.1 Resetting circuit breaker.
3. Remove the chassis covers. See
4.2.1.1 Removing the front chassis covers, Page 43,
4.2.1.3 Removing the rear chassis covers, Page 43, and
4.2.1.5 Removing the upper chassis covers, Page 44.
A
B
71