Permobil Chairman HD3, Service Manual

Page: 9 / 32

9
Batteries
Batteries
NB! Use protective goggles when working on
batteries.
Removal
1. Put the wheelchair on a level surface.
2. Raise the seat. To raise the seat manually,
see page 7.
3. Put the circuit breaker in the “OFF” position,
see fig. 9.
4. Remove the battery cover and rear cover,
see page 8.
NB! Take care when removing the rear cover; the
rear light cable is attached to the electronic unit.
5. Disconnect the battery leads, positive
terminals first.
6. To make access to the battery easier, you can
also disconnect the electrical connections for
the drive motor, magnetic brake, lights and
brake release sender. Make a careful note of
the location of the cables for reconnection.
7. Lift out the batteries.
Fitting
1. Lift the batteries into position, with the poles
at the back, see fig. 10.
2. Reconnect the battery leads, negative first.
3. Attach the electrical connections for the drive
motor, magnetic brake, lights and brake
release sender, if you disconnected
them earlier.
4. Refit the covers.
5. Put the circuit breaker in the “ON” position,
see fig. 9.
6. Lower the seat. For manual lowering,
see page 7.
Fig. 10. Battery connections
Fig. 9. Circuit breaker/Battery isolator.
On
Off