Permobil Chairman HD3, Service Manual

Page: 11 / 32

Support wheels
11
Support wheels
Removal
1. Switch of the main switch.
2. Remove the drive wheel on the relevant side,
see page 10.
3. Remove the two screws, see fig. 13.
Fitting
Fit the support wheel and spacer plate using the
two screws, as shown in fig. 14.
Adjusting
The degree of flex of the support wheels can be
adjusted using the adjusting screw on front of the
bracket. For the Chairman HD3, the support
wheel should always flex as little as possible, i.e.
the adjusting screw should be tightened right
down. When the adjusting screw is tightened right
down, it is locked by the lock washer fitted to it,
see fig. 15.
Fig. 15. Adjusting the support wheels
Fig. 14. Fitting the support wheels.
Fig. 13. Removing a support wheel.