16
Perle IRG5410/5410+Series Router Hardware Installation Guide
Power Management
• Cellular disconnected
• Ethernet disconnected
• Serial disabled
• USB disconnected
• GPS disconnected
• CPU power savings mode enabled
• LED power savings mode enabled
Power consumption was measured at 12 V.
Note:
up to 0.08A 1W more in power savings can be achieved through shutting down the USB port,
LEDs, GPS as well as turning down router processor speed.
Low Voltage Standby
This feature is intended to monitor the voltage being provided to the router in order to avoid a
depletion of the battery. Should the voltage go below a user defined threshold condition, the router
will enter Low Voltage Standby. When the voltage increases above the threshold, power will be
resumed. This is a battery protection feature and therefore will override Ignition Mode and Smart
Standby Mode. The feature can measure voltage either with the IGN pin or the GPIO (analog) pin.
See the Perle IRG5000 Series Router User’s Guide how to configure this feature.
Model
Idle Mode
Typical Use
Standby
Cu
rr
en
t (
A)
Po
w
er
(W
)
Cu
rr
en
t (
A)
Po
w
er
(W
)
Cu
rr
en
t (
A)
Po
w
er
(W
)
(4Eth, LTE-A Pro)
0.30
3.62
0.33
3.98
N/A
N/A
IRG5410 (1 Eth, LTE-A)
0.23
2.70
0.24
2.88
3.9
46.8
IRG5410 (1 Eth, LTE-A Pro)
0.25
2.94
0.28
3.30
3.9
46.8
IRG5520 (2 Eth, LTE-A)
0.30
3.56
0.31
3.77
3.9
46.8
(2 Eth, LTE-A Pro)
0.32
3.84
0.35
4.22
3.9
46.8
IRG5521 (2 Eth, LTE-A, WiFi)
0.35
4.16
0.37
4.40
3.9
46.8
(2 Eth, LTE-A, Pro WiFi)
0.36
4.37
0.40
4.79
3.9
46.8
IRG5540 (4 Eth, LTE-A)
0.32
3.86
0.34
4.07
3.9
46.8
(4 Eth, LTE-A Pro)
0.35
4.14
0.38
4.52
3.9
46.8
IRG5541 (4 Eth, LTE-A Wifi)
0.37
4.46
0.39
4.70
3.9
46.8
(4 Eth, LTE-A Pro, Wifi)
0.39
4.67
0.42
5.09
3.9
46.8
FN (2 Eth, LTE-A Pro US, WiFi)
0.36
4.37
0.40
4.79
3.9
46.8
FN (4 Eth, LTE-A Pro US, WiFi)
0.39
4.67
0.42
5.09
3.9
46.8
