Perkins SMART Brailler™ User Manual | Rev: 041814
two-tone sound. Please turn off the brailler and then turn it back
on. If you encounter additional problems after receiving this
message, please contact Perkins Products. See the section in this
manual on
Returning the Brailler for Repair
information.
Care and Storage
Cleaning the Brailler
Turn the brailler off and unplug it before cleaning it.
Use a microfiber cloth to clean the SMART Brailler™'s video screen.
Rub the cloth gently across the screen; do not use a circular motion. If
needed, lightly dampen a section of the cloth with water and gently
wipe the screen, and then go over it again with a dry section of the
cloth to wipe away any moisture. Distilled water is preferred because it
will not leave a film when it dries.
A microfiber cloth is also preferred for cleaning the body of the brailler
and the plastic parts of the Smart Module. However, another type of
soft cloth can be used. You can lightly dampen the cloth with plain
water, or water with a small amount of mild dishwashing liquid, if
needed. Dry the brailler immediately after cleaning it.
Do not allow moisture into the speaker, around the bases of the
buttons, or into the headphone jack or USB port on the Smart Module.
Do not allow moisture around the base of the power switch or into the
power supply port. Do not spray any type of cleaning liquid directly
| tel: +1-617-972-7308 | 175 North Beacon Street Watertown, MA USA 02472
39
