Perkins 1300 EDi Series, Workshop Manual, Page: 35 / 264

3
Workshop Manual, TPD 1353E, Issue 3 23
Peregrine EDi and 1300 Series EDi
To fit Operation 3-2
Special requirements
1 Clean the cylinder head and the rocker cover.
2 Renew the elements of the engine breather, if necessary, see Operation 3-3.
3 Renew the gasket for the rocker cover, if necessary.
4 Fit a new ‘O’ ring into the rocker aperture for the electrical connector.
5 Hold the rocker cover over the engine and push the rocker cover electrical connector for the wiring loom of
the fuel injector units into its hole in the rocker cover. Ensure that the four tags (A1) engage on the rocker cover.
6 Fit the rocker cover, fit and tighten the 13 setscrews (B) to 18 Nm (13 lbf ft) 1,8 kgf m.
7 Connect the wiring loom (C1) for the fuel injector units, at the rocker cover electrical connector (C2).
8 Fit a new ‘O’ ring onto the breather tube.
9 Apply clean lubricating oil to the ‘O’ ring.
10 Fit the breather pipe into the cover.
11 Fit and tighten the top and bottom setscrews of the breather tube.
Consumable products
Description Part number
POWERPART Silicon rubber sealant 1861108
W203/2
A
1
W205
B
W203/1
C
2
1
This document has been printed from SPI². Not for Resale