Perkins 1300 EDi Series, Workshop Manual, Page: 152 / 264

10
140 Workshop Manual, TPD 1353E, Issue 3
Peregrine EDi and 1300 Series EDi
Lubricating oil pump
To remove Operation 10-12
1 Drain the engine lubricating oil.
2 Remove the crankshaft pulley and damper assembly, see Operation 5-1.
3 Remove and discard the front oil seal, see Operation 10-15.
4 Remove the six setscrews of the oil pump.
Note: There are short setscrews at the 2 o’clock and the 3 o’clock positions.
5 Remove the oil pump body (A1) and discard the 'O' ring (A2).
6 Remove the outer rotor (A3).
7 Remove the key (A4).
8 Remove the oil deflector (B1).
9 Remove the inner rotor (C1).
10 Remove the backplate (D2).
11 Remove and discard the 'O' ring (D1).
W123
B
1
W122
A
1
2
3
4
W117
C
1
W116
D
1
2
This document has been printed from SPI². Not for Resale