Perkins 1300 EDi Series, Workshop Manual, Page: 144 / 264

10
132 Workshop Manual, TPD 1353E, Issue 3
Peregrine EDi and 1300 Series EDi
To fit Operation 10-3
Special requirements
1 Clean the outside of the oil filter head and cooler assembly (A7). Clean the joint face on the cylinder block,
the coolant inlet pipe (A1) and coolant outlet pipe (A5).
2 Fit new joints (A4) to the filter head and fit new ’O’ rings (A2 and A6) to the coolant inlet and outlet pipes.
3 Put the filter head and oil cooler assembly (B) in position on the cylinder block. Ensure that the coolant inlet
pipe is correctly engaged in the cylinder block and in the filter head. Fit and tighten the setscrews for the filter
head / oil cooler assembly.
4 Fit and tighten the setscrew for the clamp (A3) of the coolant inlet pipe.
5 Clean the threads of the union connection (A9) for the turbocharger pipe (A10). Apply POWERPART
Threadlock and nutlock to the thread of the connection that enters the filter head. Use a separate spanner to
hold the union connection while the union nut on the pipe is tightened.
6 Fit a new oil filter canister (A8), see Operation 10-1.
7 Fill the cooling system to the correct level.
8 Fill the sump to the correct level with lubricating oil of an approved grade, see Chapter 5 in the User’s
Handbook.
Consumable products
Description Part number
POWERPART Threadlock and nutlock
21820117 or
21820118
W059
A
1
2
3
4
5
6
6
7
9
8
10
11
W124
B
This document has been printed from SPI². Not for Resale