Perkins 1300 EDi Series, Workshop Manual, Page: 128 / 264

9
116 Workshop Manual, TPD 1353E, Issue 3
Peregrine EDi and 1300 Series EDi
Turbocharger
To remove Operation 9-1
Warning! Turbochargers operate at high speed and at high temperatures. Keep fingers, tools and other
objects away from the inlet and outlet ports of the turbocharger and avoid contact with hot surfaces.
1 Thoroughly clean the turbocharger.
2 Remove the air cleaner hose at the compressor inlet.
3 Remove the hose from the compressor outlet.
4 Release the setscrews (A1) from the flange (A2) of the oil supply pipe (A4) at the top of the bearing housing.
5 Release the union nut / connection (A6) at the other end of the pipe on the oil filter head. Use a spanner to
hold the union (A5) on the filter head when the union nut is released.
6 Remove the pipe and discard the flange joint (A3).
7 Remove the setscrews (B7) from the flange (B2) of the oil drain pipe (B5) at the bottom of the bearing
housing.
8 Remove the setscrew (B4) and the clamp (B3), at the other end of the pipe.
9 Remove the oil drain pipe and discard its two ’O’ rings (B6) and flange joint (B1).
10 Hold the turbocharger and release the setscrews that retain the turbocharger to exhaust manifold. Remove
the turbocharger and discard the gasket.
11 Cover the openings in the manifolds and the pipes to ensure that debris will not enter.
W098
A
2
3
4
6
5
1
W099
B
1
2
3 6
4
5
7
This document has been printed from SPI². Not for Resale