PerkinElmer RamanStation 400, Getting Started Manual

Page: 87 / 118

Using the RamanStation 400 .
87
General SOPs
SOP-1: Switching the System On
1. Switch on the PC and monitor.
2. Login to Windows.
3. Ensure the laser power key is in the ARM position on the rear panel of the instrument.
4. Ensure the main power supply is connected to a mains outlet and that the outlet is
switched on.
5. To turn on the spectrometer, press the PSU power switch ON (Figure 29):
 - ON Ο - OFF
Figure 29 The PSU power switch
6. Check that the Power LED on the instrument keypad is On.
The Laser LED and the Active LED should be off. If the Power LED is not on, please turn
the instrument off at the PSU and check all of the connections, any power socket
switches and then switch the PSU on again.
7. If appropriate, connect the stage controller power supply to a mains outlet and ensure
that the outlet is switched on.