PerkinElmer RamanMicro 200 Series, Getting Started Manual

Page: 45 / 98

Installing Your RamanMicro 200 Series . 45
Connecting the Raman Module to the Microscope
The Raman module is positioned on top of the illuminator module so that the connecter
bracket is aligned above the mounting hole. Ensure that the side of the Raman module is
aligned with the illuminator module and then tighten the grub screw.
Figure 18 Connecting the Raman module
Connecting the Alignment Camera to the Raman
Module
The alignment camera module is then connected into the mounting bracket on top of the
Raman module, and the screws tightened.
NOTE: Do not attach more than two alignment cameras in the Raman system.
Figure 19 Connecting the alignment camera
NOTE: Do not connect the USB from the camera to the PC until after the software is
installed. See
Installing the Instrument in Spectrum Software
on page 49.
Alignment camera
Mounting bracket
Screw
Raman
module
Illuminator
module
Screw