PerkinElmer Raman IdentiCheck, Getting Started Manual

Page: 54 / 78

54 . Raman IdentiCheck Getting Started Guide
12. Leave the system to equilibrate.
When you start the software the instrument will prepare for use. The laser will be
turned on. The Laser LED on the instrument and the Probe Path LED on the probe will
come on. The detector will be cooled to its operating temperature (usually −50
o
C).
How long this takes will depend on the environmental conditions; up to 30 minutes at
30 °C, as an extreme example.
Messages will be displayed in the Status bar at the bottom of the workspace, and in the
Scan icons on the Measurement bar to advise you of the progress of this.
You are now ready to start using the instrument.
NOTE: While the instrument is on, make sure not to cover the fans or close the lid of the
transport case.
SOP-2: Packing up the Instrument after use
When you have completed your work, follow the steps described below to shut-down and
pack up your instrument.
1. Shut down Spectrum software by selecting
Exit
from the File menu to return to the
Windows operating environment.
2. Remove the laser power key and, if appropriate, the interlock override.
3. Switch off the power supply and then unplug the power supply unit.
4. Shut-down your PC and then disconnect the triggered fiber optic probe USB extender
cable.
5. Disconnect the USB cable that connects the PC to your IdentiCheck.
6. If appropriate, remove the plastic spacer from the end of the triggered fiber optic probe
and fit the lens cap.
7. Carefully coil-up the triggered fiber optic probe cable and place it in the foam
compartment.
8. Ensure that the power supply unit and, if appropriate, the tablet PC are secured, using
the straps provided, within the lid of the case.
9. Pack the following items in the cable bag:
• The laser power key.
•
The IdentiCheck power supply unit power cable.
•
Your PC power supply unit and cables.
• The USB cable that connects your PC to the instrument.
10. Place the cable bag in the case, above the right-hand panel.
11. Shut the case, ready for transport.
NOTE: For further information on transporting your IdentiCheck see Moving the Instrument
on page 24.