Performance Travel Trac 2000, Manual

Page: 1 / 4

Thank you for purchasing the Performance Travel Trac 2000™ portable trainer.
The Travel Trac 2000™ was designed to provide maximum stability and ease of
use in a convenient, portable folding trainer.
This trainer offers many notable features which make it a good choice for your
training needs:
• Extremely stable and rigid design.
• Easy setup and bicycle installation.
• Spring loaded resistance positioning system to prevent
excessive tire wear.
• Quickly folds flat for storage and easy portability.
• Choice of resistance units available separately.
(A resistance unit is required for operation.)
Travel and Storage:
1. Release the spring plate lock by pushing down on the spring plate with the palm
of your hand, and then pulling up on the spring plate release lever with your
fingers. Allow the spring plate to slowly rotate all the way up (Fig. 1). To prevent
a pinching hazard, never store the Travel Trac 2000™ with the spring plate locked
down.
2. Coil any resistance unit cables and hang over handle.
3. Grasp the Travel Trac 2000™ by the handle and lift. The legs should then fold,
and the trainer is ready for transport or storage. Be careful to avoid pinching
when the legs fold.
CAUTION:
1. This trainer is intended for single-rider bicycles only.
2. Check for proper and secure installation of the bicycle before beginning
each workout.
3. Make sure that resistance unit cables are clear of all moving bicycle parts.
4. Do not leave trainer unattended with spring plate mechanism in locked
(down) position. This could present a potential pinching hazard to
children.
Bicycle Removal:
1. Push the spring plate down as far as possible towards the floor to
automatically engage the spring plate lock. The spring plate must be
locked down to remove the bicycle (Fig. 6).
2. Slide the Travel Trac 2000™’s locking ring ( Fig. 3A) to the right
(away from the bike).
3. While supporting the bicycle, loosen the right side axle support with the
handle, until bicycle is free of the support cups.
Folding Bicycle Trainer
Assembly:
1. Remove from the box and identify all parts for assembly. If you believe
parts are missing, please contact our technical service department for
assistance at 1-800-727-2453 from 9 am to 6pm EST.
2. Assemble feet to legs as shown. (Fig. 1)
3. Assemble handle to axle support with a light tap as shown. (Fig. 1)
Performance Tech Support 1(800)727-2453
9am-6pm EST Monday-Friday
®
™
Performance, Inc.
One Performance Way
Chapel Hill, N.C. 27514
Made in Italy
www.performancebike.com