4. Slide the remaining handle through the shelf on
the opposite end, and repeat steps 2 thru 3.
5. Slide the remaining shelf onto the handle, lining
up the holes on the side of the shelf with the
holes on the handle nearest the bottom of the
cart.
6. Insert bolts (3) through the shelf and handle on all
four corners and secure with a washer (4) and
hex nut (5).
7. Go back and check to make sure all fasteners are
tight.
8. Turn utility cart upside down and place on a flat
surface.
9. Place a cross bar (6), both side brackets (8) and
back drawer cover (13) onto underside of the top
shelf. (NOTE: Make sure the rails on the side
brackets are facing toward each other. The
closed ends of the rails must face the drawer
back cover or rear of the cart, when attached to
the utility cart. See close up.)
10. Align the holes on the crossbar (6), both side
brackets (8) and back drawer cover (13) with the
holes in the corners of the shelf underside.
11.Insert bolts (9) through the shelf at each corner,
attaching the crossbar (6), both side brackets (8)
and back drawer cover, and secure each bolt
with a washer (10) and 14mm hex nut (11).
12. Attach remaining crossbar (6) to side brackets
(8) and fasten together with bolts (9), washers
(10) and hex nuts (11).
13. Fasten together the side brackets (8) to the
drawer back cover (13) with bolts (9), washers
(10) and hex nuts (11).
14. Go back and check to make sure all fasteners
are tight.
CLOSED
OPEN
