Scan sensitivity setting – FM
The radio will normally scan all stations from FM broadcasts including the weaker
signals. However, you may wish the Auto-scan to find only those stations with strong
enough signals to give good reception.
1. Press the
On/Off button
to turn on the radio.
2. Select the FM band by pressing the
Source button
.
3. Press the
Menu button
, the display shows “Scan setting”.
4. Press the
Tuning knob
.
5. Rotate the
Tuning knob
to select between “All stations” or “Strong station” (default
is All stations).
The “Strong station” option will allow the radio to find strong signals only when
scanning.
6. Press the
Tuning knob
to confirm your setting. The display will return to normal
radio display.
PRESET STATIONS
Storing preset stations
There are 20 memory presets in the radio, 10 for DAB and 10 for FM. Presets are
remembered by the radio in the event of a power failure.
1. Press the
On/Off button
to turn on the radio.
2. Press the
Source button
to select the desired waveband.
3. Tune to the required station.
4. Press and hold the required
Preset button
until the radio beeps and shows for
example “Preset 01 Saved”.
5. Repeat step 3 and 4 for the remaining presets.
6. Stations stored in the preset memories can be over-written by following the above
procedure.
Recalling preset stations
1. Press the
On/Off button
to turn on the radio.
2. Press the
Source button
to select the desired waveband.
3. Briefly Press the required
Preset button
, the display will show for example “Preset
01 Loaded” for a few seconds and the radio frequency.
11
